Problems!

Feb 11, 2024 Everything was working fine until a reboot of the Raspberry Pi was needed. Then it all went wrong! It wouldn't come back up & the SD card had managed to corrupt itself destroying the boot & not being able to recover even after trying to install a new OS over the top of the old one. On the plus side all the critical data, the software to run the modules was recovered, eventually.

Another thing that has gone wrong. A smart switch kit was purchased but due to rushing to put it together, it might have been killed so with that being a waste of money, a single switch might be used with the old monitor port a great slot for it to be located!

Feb 25, 2024: Another problem as occurred, the 3D printer has suffered an issue. Not sure what it is but that has now been put away for another part of this project!

After this calamity, hopefully everything else will go as planned but then again...

Problems!

Menu